John Deere Gator Manual

John Deere Clutch

Tired of grinding the hand clutch on your two cylinder Deere tractor? Do not worry, the design specs of these tractors allows for relatively easy access and repair of the John Deere clutch. Unlike with many other tractors. the clutch on the lay down John Deere tractors needs no splitting of the rear end of the tractor from the torque tube, to reach the clutch mechanism. Built in Waterloo Iowa these tractors are referred to as "lay downs" by some because the engine has horizontally opposed cylinders. Waterloo built 2 cylinder tractors including the A, B, D, G, GP, H, R, 50, 60, 70, 80, 520, 530, 620, 630, 720, 730, 820, 830 and variations. To get to the clutch detach the clutch cover from the side of the tractor. These covers are held by compressions and likely dented as a result of the force necessary to remove and install the clutch cover. If a new clutch cover is needed check out the clutch covers at Steiner Tractor Parts (STP).

Their most in demand cover is the JDS543 which fits with late models A and G up through the 630 and 730 tractors. After you take it off you will need to disassemble the clutch. For instructions it is best to consult your manual. If you do not have one STP can help. Manuals are available on their web site: Steiner Tractor Parts. Once apart, take a look at the clutch facings and bonded clutch discs. These pieces will wear out as they bear the friction that engages the transmission. After inspection, examine the teeth on the slider disc(s) and the clutch driver for wear or damage. Either one or two slider discs are used, depending on the model.

Replace as needed. Next inspect the clutch dogs, springs, T-bolts and the slotted hex nuts for wear or damage. The belt pulley brake lining is another high wear item. Make sure to inspect the lining for wear. Lastly if the hand clutch has too much play then you may need to replace the clutch lever pivot bushing and possibly the pivot bolt. Good thing Steiner Tractor Parts (STP) stocks a comprehensive selection of drivers, discs, clutch facings and covers, bonded linings, T-bolts, clutch dogs, springs, slotted hex nuts, pivot bolts and clutch lever pivot bushings along with the belt pulley lining. With online convenience and low pricing STP is a clutch resource for John Deere tractors.